NL Set up and connect
2. Remove the transport
reinforcements.
4.6 Connecting device
Connect water supply hose
1. Connect the water supply hose to
the appliance.
3. Loosen and remove the screws of
the horizontal transport
reinforcement with a T20
screwdriver.
2. Connect the water inlet hose to the
tap (26.4 mm = 3/4").
4. Remove the transport
reinforcement.
3. Open the tap carefully and check
that the connections are tight.
Water drainage connection types
The information will help you connect this
appliance to the water outlet.
PAY ATTENTION!
When draining, the water drain hose is
under pressure and can come loose
from the installed connection position.
▶
Secure the water drain hose against
unintentional disconnection.
16
To Next Page
Loading...
