NL Troubleshooting
Malfunction
"E:30 / -80"
Cause and Troubleshooting
▶
When dosing manually, reduce the amount of
detergent for the next wash with an equal load.
Unauthorized extension mounted on the water drain
hose.
▶
Remove any unauthorized extensions from the
water drain hose. Connect device
Pump cover is not fully screwed in.
▶
Make sure that the pump cover is screwed into the
device as far as it will go. The pump cover handle
must be vertical.
"E:36 / -25 / -26" Drain pump is clogged.
▶
→
"Cleaning the drain pump", page 39
"E:38 / -25 / -26" Drain pump is clogged.
▶
→
"Cleaning the drum", Page 37
if the fault is displayed again,
▶
→
"Cleaning the drain pump", page 39
Inlet opening of the rubber sleeve is clogged.
▶
→
"Clean the inlet opening in the rubber sleeve",
Page 42
"E:10 / -00 / -10 /
- 20"
Pump of the intelligent dosing system is blocked.
1. Switch off the device.
2. Clean the pump unit.
→
"Cleaning the detergent drawer",
Page 38
3. If the indication reappears, enable the service.
→
"Customer Service", page 56
Remark: You can start the washing program if you
deactivate the intelligent dosing system and dose
manually.
→
"Buttons", Page 25
Water pressure is low.
No solution possible.
The strainers in the water supply are clogged.
▶
Clean the strainers in the water supply.
Water tap is closed.
▶
Open the water tap.
Water supply hose is kinked or pinched.
44
To Next Page
Loading...
