09 BATTERY POWER 9.2 Battery Removal
44
Battery removal:
Please note the removal and installation of your E-Lyte’s electrical
system requires an advanced technical knowledge and may therefore
be beyond the skills of average users. If you have any doubts, please
contact your Whyte retailer for assistance. To remove the battery please
refer to the part description table on the right and follow the step by
step guide aided with illustrations. Whyte recommends where possible
to always use an authorised retailer for removal and installation of
electrical components. Any damage derived from incorrect installation
may void warranty.
WARNING!
When transporting your Whyte EPAC where the bike is exposed
(EG. tow bar racks), it is recommended that battery is removed.
If there was an accident where the frame and battery are
crushed, this could trigger an electrical re.
Tools required to remove battery:
• Bosch Lock Ring Tool
• T20, T25 Torx screwdriver
• TP40 Torx PLUS screwdriver
• Torque Meter Wrench (Optional)
CAUTION!
Whyte recommends that the installation/removal of the battery
should be carried out with the bike positioned in a repair
stand. There needs to be ample room to slide the battery out
of the frame. Take precautions to avoid dropping the battery
onto a hard surface. Alternatively the bike could be placed on
its non-drive side. Avoid tipping the bicycle upside down due
to the weight of the bicycle. This may also lead to handlebar
components being damaged.
ITEM Part/Location Description Spare Part Kit Code
1 Skid Plate WHYE-32
2 M5 x 12mm Countersunk screw
WHYE-27
3 Drive Side Motor Cover
4 Non-Drive Side Motor Cover
5 Bosch Lock-Ring EB112000JH
6 Chain Ring N/A
7 M4 x 12 Screw WHYE-27
8 Bosch Motor N/A
9 Motor Nut EB1120003C
10.1
10.2
Motor Bolt (Long)
Motor Bolt (Short)
EB112000NA
EB112000N9
11 BCC (Motor-Battery) Cable EB12120034
12 HMI TT Controller EB12120007
13 M5 x 12 Bosch Screw EB1211001B
14 BCC (COBS - Battery) Cable EB12120049
15 Battery EB12100020
16 Battery Adapter EB12100015
To Next Page