12 MAINTENANCE & SERVICING 12.6 Bearings & Washers
66
Bearing Insertion
Before inserting the bearings, make sure all the components are clean
from dirt and have been thoroughly de-greased. To press bearings into
the mating component, apply a small amount of Locktite 638 to the
outside diameter of the bearing and to the inside bore of the mating
component. Next, assemble the components in the sequence of the
illustrated exploded views. It is very important to make sure the bearing
and bearing Insertion tool are squarely seated against the mating
component. With great care, slowly tighten the press until you can see
the bearing being pressed squarely into the mating component. Once
the bearing is fully seated and you can no longer tighten the press,
remove the bearing press tool. Remove any excess Locktite from around
the bearing, particularly in any internal threads.
INFO: Locktite may need time to cure. Ensure you follow the
products instructions for correct application and cure time.
Re-assembly of shield washers / spacers
Apply a good quantity of grease on top of the bearings (recommended
grease applications: SKF LGEP2, Castrol Spherol AP3, Finish Line Teon
White Lithium-Complex). The grease should completely cover each
bearing and be applied on both sides of each bearing subsequent to
the bearing being pressed into it’s housing in the relevant component.
Assemble the shield washer components to reect the exploded views
in this manual. If you have applied enough grease, it should spread from
under the shield washer or spacer components as they are positioned.
Wipe this excess grease away from around the shield washer or spacer
components.
CAUTION: Whyte recommends the correct tools and products
are used at all times when performing maintenance to your
bicycle. Substitute products can damage your bicycle and
warranty. Please contact your Whyte retailer for assistance if
in doubt.
WARNING! Do not pressure wash bearings as important
greases will be stripped. This can damage the bearings and the
frame whilst affecting the performance of your bicycle.
INFO: Build up of dirt or grit in bearing housings can cause
premature wear. Damage due to lack of maintenance/cleaning
is not covered by your Whyte warranty.
INFO: Always check pivot bearings before every ride. Bearings
should last between 75-125 hours of riding or every 12 months,
which ever comes rst. This is dependant upon riding style
and conditions.
To Next Page