02 - RIDE INFO 2.1 Out the Box
This manual is not intended as a comprehensive guide to assembling,
servicing, or maintaining your bicycle. Please see your authorised Whyte
Bikes retailer for assembly guidance, service, repairs, and maintenance.
INFO: Specication of all the components that are tted to your
bike as standard may be obtained from the Whyte Bikes website
www.whyte.bikes.com
8
WARNING: If you are in any doubt about your ability to safely
service or repair your Whyte bike, DO NOT RIDE IT and instead
arrange for a professional bicycle mechanic at your local Whyte
retailer to do the job correctly.
WARNING: Before any ride, check all xings tight and secure,
this is very important to ensure the bikes performance and your
safety. Please read the Pre-Ride Checks section of this manual
and learn what is required to operate this bicycle. Correct
tightening force on fasteners (nuts, bolts and screws) is critical.
Too much force can cause damage to the xing and too little
force could cause them to undo or rattle loose. Where indicated
in the instructions or printed on the xing, please adhere to the
recommended torque specication. Please see the table to the
right of this page for recommended tools and torque settings.
Tools Required For Assembly:
• 4,5,6,8mm Allen key
• Adjustable spanner
• Bicycle Pump
• Torque Meter Wrench
(Optional)
To Next Page