Bosch WNA144V9GB - Troubleshooting Common Issues; Appliance Not Working and Door Issues

en Troubleshooting
42
Fault Cause and troubleshooting
There are detergent
residues on the laun-
dry.
Detergents may contain water-insoluble substances
that deposit on the laundry.
▶ Start the Rinse programme or brush out the
laundry after drying.
Fluff on the laundry. Fluff has accumulated in the drum.
▶ Start the Cottons ⁠90° programme without any
laundry or detergent.
The laundry is too wet
after the spinning
cycle.
A low spin speed is selected.
▶ Start the Spinprogramme.
▶ The next time you run a wash cycle, set a higher
spin speed.
The appliance is using a reduced spin speed to elim-
inate an imbalance.
1. Redistribute the laundry in the drum.
2. Start the Spinprogramme.
⁠Reduced Ironing is activated.
▶
Set a suitable programme. →Page25
The laundry is too
damp.
The selected programme is unsuitable for the type of
fabric.
▶ Set a suitable programme for subsequent drying.
→Page25
The load is too large.
▶ Observe the programme's maximum load capacity.
→Page25
After the end of the programme, warm laundry feels
damper than it actually is.
1. Remove the laundry from the drum as soon as the
drying programme has finished.
2. Spread the items of laundry for cooling.
The selected dryness level is unsuitable.
▶
Change the dryness level. →Page32
The load is too small.
▶ Set a suitable programme for subsequent drying.
→Page25
The laundry has not been spun sufficiently.
▶ Always select the highest possible spin speed for
the washing programme in question.
Creasing. The selected programme is unsuitable for the type of
fabric.
▶
Set a suitable programme. →Page25