Bosch WNA144V9GB - Troubleshooting Common Issues; Programme Start and Door Opening Issues

Troubleshooting en
43
Fault Cause and troubleshooting
Creasing. A high spin speed is selected.
▶ The next time you run a wash cycle, set a lower
spin speed.
The load is unsuitable.
▶ Observe the programme's maximum load capacity.
→Page25
▶
Prepare the laundry. →Page29
The laundry lies in the drum for too long after drying.
1. Remove the laundry from the drum as soon as the
drying programme has finished.
2. Spread the items of laundry for cooling.
Easy Care fabrics have been dried for too long.
▶
Change the dryness level. →Page32
Water is leaking out at
the water inlet hose.
The water inlet hose is not correctly connected or is
damaged.
▶ Check the installation of the water inlet hose.
→Page13
Replace the water inlet hose if it is damaged.
Water is leaking out at
the water outlet hose.
The water outlet hose is not connected correctly or is
damaged.
▶ Check the installation of the water outlet hose.
→Page13
Replace the water outlet hose if it is damaged.
Water is leaking from
below the door.
Dirt on the door or seal causes leaks.
▶ Clean the door and the seal.
Detergent or fabric
softener drips off the
seal and collects on
the door or in the seal
fold.
There is too much detergent or fabric softener in the
detergent drawer.
▶ When dosing, observe the marking in the detergent
drawer.
Residual water is
present in the com-
partment .
Insert in compartment is blocked.
▶
Clean the detergent drawer. →Page34
Fabric softener re-
mains in the detergent
drawer.
The use of fabric softener is not supported for the se-
lected programme.
▶ Check whether the use of fabric softener is suppor-
ted for the selected programme. →Page25