10
Operation
6 720 612 217 (05.03)
5Operation
5.1 General information
The TDS 10 basic settings are
already pre-programmed to suit the
most common applications.
5.2 Controls
For overview of controls, see Fig. 1 on
page 16.
i
Information to be given
to the user by the in-
staller:
B Explain to the user
how to operate the
controller.
B Give the user all the
documents supplied
with the controller.
Control
Description
Display
Factory
setting
S set to
automatic
mode AUT
E.g. 48 °C
moves / stops
Display backlight-
ing yellow
S set to
manual
mode, solar
heating
pump ON
ON flashes
moves
Display backlight-
ing red
S set to
manual
mode, solar
heating
pump OFF
OFF flashes
stops
Display backlight-
ing red
Changes display to next setting or
increases figure
Press and hold: switches to maxi-
mum storage tank temperature
setting
Press and release: saves settings
and switches to automatic mode
Changes display to previous set-
ting or reduces figure
Table 4
To Next Page
Loading...
