Troubleshootingen
Disturbance Cause and troubleshooting
Spin program
does not start.
A notice:Put large and small items of laundry together
in the drum. Items of laundry of different sizes spread
out better when spinning.
▶ Start the programSling .
rushing, zi-
hissing sound.
Water is flushed into the detergent drawer under
pressure.
▶ No error - normal operating noise.
Loud noises during
end of skidding.
Device is not aligned correctly.
▶
→
"Align device", page 17
Device feet are not fixed.
▶ Fix the device feet.
→
"Align device", page 17
Transport locks are not removed.
▶
→
"Remove transport locks", page 14
.
rattling noises,
Rattling in the drain
pump.
Foreign body has gotten into the drain pump.
▶
→
"Cleaning the drain pump", page 34
Slurping, rhythmic
cal sucking noise.
The suds pump is active, the suds are pumped out.
▶ No error - normal operating noise.
wrinkling. Spin speed is too high.
▶ Set a lower spin speed for the next wash cycle.
Load quantity is too high.
▶ Reduce the load for the next wash cycle.
Unsuitable program set for the type of fabric.
▶ Select suitable programs for the type of fabric.
detergent or
Fabric softener drips off
the cuff and
collects on the door
or in the cuff fold.
Too much detergent/softener in the detergent drawer.
▶ When dosing liquid detergent and fabric softener,
pay attention to the mark in the detergent drawer
and do not exceed the dosing.
spin result is
unsatisfactory
lending The laundry is
too wet / too damp.
Low spin speed is set.
▶ Set a higher spin speed for the next wash cycle.
▶ Start the programSling .
45
To Next Page
