Bosch ZBR 100-3 - Connection of the Control Units; Installation of the Strain Relief

Electrical connection
17
Condens 5000W – 6720813952 (2019/02)
[4] Other rooms
[5] Living space
[6] Installation location
[7] External
[8] Outdoor temperature sensor
6.2 Connection of the control units
Electrical work must only be carried out by qualified electrical
contractors.
The terminal strip is located behind the cover.
 Unscrew the control panel and hang on the frame.
Fig. 26 Mounting the user interface
 Turn the locks a quarter turn clockwise then remove the cover.
Fig. 27 Removing the cover
 Connect the components to the relevant plug.
Fig. 28 Terminal strips
[1] 24 V AC terminal strip
[2] 230 V AC terminal strip
6.3 Installation of the strain relief
 Always pass the cable to be installed through a supplied strain relief
mechanism before attaching it to a mains plug.
 Trim the grommet of the strain relief according to the dimension of
the cable.
 Always pass the cable to be installed through a supplied strain relief
mechanism.
Fig. 29 Cable entry
 Fasten the corresponding plug to the cable.
 Plug the plug in at the terminal strip.
 Tighten the screw of the strain relief.
Fig. 30 Tightening the screw
0010010004-001
2x
0010010005-001
45°
0010010006-001
2
1
0010010007-001
A
B
0010010008-001