40 | Installation
Greenstar6 720 806 992 (2015/03)
For installations in Canada, field supplied plastic vent piping must
comply with CAN/CGA B149.1 (latest edition) and be certified to the
Standard for Type BH Gas Venting systems. ULC S636 Components of
this listed system shall not be interchanged with other vent systems or
unlisted pipe/fittings. All plastic components and specified primers and
glues of certified vent systems must be from a single manufacturer and
not intermingled with other system manufacturer's vent system parts.
The supplied vent connector and separate available vent termination are
certified as a part of the Greenstar Boiler.
PP-Flex 3" (80 mm) vent or
air pipe M&G
Duravent PolyPro and
Centrotherm
InnoFlue
ANSI Cat IV
Approved Polypropylene
BH Gas venting systems,
ULC S636
1)
,
Class IIA - PVC,
Class IIB - CPVC,
Class IIC - Polypropylene
(certified to ULC S636)
XXXXXXX
PP-Flex 2" (50 mm) vent or
air pipe M&G
Duravent PolyPro and
Centrotherm
InnoFlue
ANSI Cat IV
Approved Polypropylene
XXX XX
PVC Pipe cement/primer ANSI/ASTM D2564 XXXXXXX
CPVC ANSI/ASTM F493 XXXXXXX
1) Components of the certified vent systems must not be interchanged with other vent systems or unlisted pipe fittings. Plastic components, and specified primers and glues of
the certified vent system must be from a single system manufacturer and not intermixed with other system manufacturer's vent system parts.
Material Item United states Canada
ZBR16-3A
ZBR28-3A
ZBR35-3A
ZBR42-3A
ZWB28-3A
ZWB35-3A
ZWB42-3A
Table 17 Materials for pipe
Roof terminals Material Supplier Part number
Ø 3" / Ø 5" (Ø 76/125 mm) concentric PVC IPEX System 636 196006
Ø 3" / Ø 5" (Ø 76/125 mm) concentric CPVC IPEX System 636 197009
Ø 3" / Ø 5" (Ø 80/125 mm) concentric PP M&G Duravent PolyPro and Centrotherm
InnoFlue
3PPS-VK (-TC) (M&G Duravent) or
ICRT3539 (Centrotherm)
Ø 3" (80 mm) PolyPro Flex Chimney Cap (PP) M&G Duravent PolyPro
Centrotherm InnoFlue
3PPS-FCT
ISCP03
with base support PolyPro Support Elbow
Base Suport + SW to Flex Coupler
M&G Duravent PolyPro
Centrotherm InnoFlue
3PPS-SE90X
ISBS0387 + IFSFC03
Ø 2" (50 mm) PolyPro Flex Chimney Cap (PP) M&G Duravent PolyPro
Centrotherm InnoFlue
2PPS-FCT
ISCP02
with base support PolyPro Support Elbow
Base Suport + SW to Flex Coupler
M&G Duravent PolyPro
Centrotherm InnoFlue
2PPS-SE90X
ISBS0287 + IFSFC02
Table 18 Roof terminals
Wall terminals Flue System / Materials Supplier Part number
Ø 3" (Ø 76 mm) parallel stainless steel Flex-L 46546901
90 °-elbow with
inlet screen
PVC (elbow)
stainless steel (screen)
IPEX (elbow)
Langly Wire (screen)
ULC S636 approval (elbow)
L2594 (screen)
Ø 3" (Ø 76 mm) twin pipe termination PP M&G Duravent PolyPro 3PPS-HTP
Ø 3" (Ø 76 mm) single pipe termination PP M&G Duravent PolyPro 3PPS-HST
Ø 3" / Ø 5" (Ø 80/125 mm) Bosch Greenstar
Horizontal Telescopic Terminal Kit
PP Bosch (manufactured by
M&G Duravent)
7738003218
Table 19 Wall terminals
NOTICE:
▶ DO NOT use cellular core pipe.
▶ DO NOT use PVC when using anti-freeze in the
primary circuit of the boiler. Use CPVC, PP or
stainless steel only!
To Next Page
Loading...
