Why is there no audio signal from my Bose Music Equipment mono input module?
To fix the issue of no audio signal from a mono configured Local Input Module on your Bose Music Equipment, make sure the audio cable is connected to the LEFT output connector of the CS-LIM.
Why is there no sound in my Bose ControlSpace AMS-8 zones?
Verify that there is an input signal from the source and an output signal. If an input signal exists but there's no output, the ControlSpace™ might be muted, or the output levels may be set too low.
What to do if my Bose ControlSpace AMS-8 sound is distorted?
If the input source signal is clean when it enters the CS AMS-8 system, verify that the loudspeakers are not being overdriven and are not damaged.
Why is the sound low on my Bose ControlSpace AMS-8 Stereo System?
Check that the audio input indicator is green. If it's off, increase the source output or the input gain. If both the audio input and output signal indicators are green, ensure there is adequate gain in the amplifier and check the output levels.
Why is there no sound in one or more zones of my Bose ControlSpace AMS-8 Stereo System?
Check all connections on the CS AMS-8 system rack. Check the amplifier is operating correctly and gains are adjusted appropriately. Verify the default settings and maximum volume settings of the room in the installer software or on the system rack.
Why is the Talk LED flashing on my Bose Music Equipment paging panel?
To troubleshoot the flashing Talk LED (red and green) on the paging panel of your Bose Music Equipment, check the communication cabling between AMS-8 and the paging panel. Also, ensure the termination jumper is set at the last CS-PP.
What causes distorted sound in Bose Music Equipment?
If the sound from your Bose Music Equipment is distorted, and the input source signal is clean when it enters the CS AMS-8 system, verify that the loudspeakers are not being overdriven and are not damaged.
How to troubleshoot unnatural sound from Bose Music Equipment?
To resolve unnatural sound issues with your Bose Music Equipment, verify that the correct speaker EQ or crossover is used in the signal path. Also, make sure the input signal is not distorted or too high.
How to fix no paging/dingdong from user software on Bose Signal Processors?
If you are not getting any paging or dingdong sounds from the user software, check the cabling between your PC soundcard, microphone, and the system rack. Also, verify the volume settings of your PC soundcard.
What to do if there is no communication between PC and Bose Signal Processors AMS-8 system rack?
If you're experiencing a lack of communication or control between your PC and the Bose AMS-8 system rack while using the Privileged User Software, verify the RS232 cable connecting your computer to the AMS-8 system rack. Try shortening the cable length to a maximum of 10 meters. If you're using a PC-Kit, restart the software. Also, check the LAN connection between your computer and the AMS-8 system rack. If the connection appears fine and you still receive messages like 'No System Rack Found' after restarting, contact your Bose Professional Systems dealer.
Details the functionality of the event scheduler for automated system actions.
Details the operation and features of the wall-mounted controller.
Explains how to use the infrared remote for the wall controller.
Details how to control room settings like source and volume via software.
Explains the software interface for paging into specific rooms/zones.
General| Brand | Bose |
|---|---|
| Model | ControlSpace AMS-8 |
| Category | Stereo System |
| Language | English |
To Next Page
