Installation Guide - 25
Technical Information
pro.Bose.com
Recommended Amplifier and Signal Processing
System designs that have any of the following requirements require use of a Bose ESP engineered sound
processor
• Adding Room EQ in addition to on-board Loudspeaker EQ
• Independent EQ/ gain control for each beam when using dual beams (requires Dante card in ESP)
• Recalling beam steering preset using hardware controllers or CSR remote (requires Dante card in ESP)
• Parameter Set Control of typical Functions (Gain, Mute, Input Type) using hardware controllers or CSR remote
(requires Dante card in ESP)
Recommended DSP and Control hardware
DSP
• ControlSpace® ESP-880, ControlSpace® ESP-1240, ControlSpace® ESP-1600, ControlSpace® ESP-4120
• ControlSpace EX-1280C
Control (Requires ControlSpace® ESP product)
• ControlSpace® CC-64, CC-1, CC-2, CC-3, CC-1 and ControlSpace® Remote App
System Setup
To use the MSA12X, download and install the latest version of ControlSpace Designer software. Visit pro.Bose.
com to download the latest software version, which includes product firmware, the latest algorithms, and a
detailed help system that guides system designers and installers through configuring the MSA12X for use in high-
quality audio systems.
With a network connection in place and ControlSpace Designer software installed, use the Update Firmware tool
inside ControlSpace Designer software to scan and update the MSA12X. Once the status reads “Up-to-Date” in
the firmware panel, proceed with your system design using ControlSpace Designer software. For full details on
using ControlSpace Designer software to configure, control, and monitor the ESP processor or entire systems
built with Bose networked system electronics, visit pro.Bose.com and download the ControlSpace Software Guide
or use the help system inside the software.
Additional Information
Refer to the owner’s guide (online at pro.Bose.com) for more information about your product (including
accessories and replacement parts). To request a printed copy, use the phone numbers provided.
Dante® is a registered trademark of Audinate.
Limited Warranty
Your product is covered by a limited warranty. Visit pro.Bose.com for warranty details.
The warranty information provided with this product does not apply in Australian and New Zealand. See our
website at www.bose.com/au/warranty or www.bose.com/nz/warranty for details of the Australian and New
Zealand warranty.
Date of Manufacture
The eighth digit in the serial number indicates the year of manufacture; “7” is 2007 or 2017.
To Next Page
Loading...
Need help?
General