English - 17
Alternate Setup
Option 2
This figure shows two source connections using a coaxial cable
and analog cable.
Audio OUT
Source 2
Audio OUT
Source 1
System connector panel
Using two sources connected to the system
Power off sources when not in use. In order for one source to
deliver audio to the system, your other source must be off.
Connecting a TV headphones connector to
the system
If your TV only has a headphones connector, use a 3.5 mm to RCA
stereo cable (not provided) to connect to the system.
1. Insert the stereo plug into the TV headphones connector.
2. Insert the red plug into the R connector on the system.
3. Insert the white plug into the L connector on the system.
4. Ensure your TV speakers are on. Refer to your TV’s owner’s
guide for more information.
5. To ensure optimal volume control from the system,
• Set your TV’s volume to 75 percent of maximum.
• Next, set the volume level of the system using the
remote control.
System connector panel
Audio OUT
TV headphones connector panel
(or other variable audio output)
3.5 mm Stereo cable
(not provided)
To Next Page
Loading...
