English - 13
Operation
Connecting a device using the AUX connector
You can use your speaker with any device that features a headphone or audio
output. This feature requires using a stereo audio cable with a 3.5 mm plug on
one end to connect to the AUX IN input
on the speaker. This type of cable is
available for purchase at electronics stores.
To use the AUX IN connector:
1. Plug the cable from your audio device into the AUX IN connector
on the
back of the speaker.
2. Press Power
on the speaker.
3. Press
AUX on the speaker.
4. Adjust the volume on the connected device to near maximum, then use
the speaker volume buttons to adjust the volume level.
Notes:
• If the connected device stops playing audio for 30 minutes, the speaker
automatically turns off to conserve battery power.
• The SERVICE connector on the back of the speaker is only for software updates.
It cannot be used to connect an audio device.
To Next Page
Loading...
Need help?
General