23
DISASSEMBLY PROCEDURE
1. Front Grill Removal
1.1 Figure 3. Turn the unit upside down, peel
off the rubber foot which attaches to the front
grill, to reveal the screws that are beneath it.
Note: Use a new rubber foot when assem-
bling. Rubber foot part 729759-0010.
1.2 Figure 4. At the location shown, remove
all three screws that attach the front grill to the
cabinet.
1.3 Figure 5. Turn the unit face up and using
your thumb, push the top of the grill in the
direction shown to detach the front grill from
the cabinet.
1.4 Figure 6. With the front grill removed,
you will have access to the IR board, Keypad
board, FFC and the transducer.
Figure 3. Rubber Foot
Figure 4. Front Grille, Screws
Figure 5. Front Grille
Figure 6. Cabinet, Front
To Next Page
Loading...
