Bose SoundTouch 10 - Page 24

24
DISASSEMBLY PROCEDURE
2. IR PCB Removal
2.1 Complete step 1.
2.1 Figure 7. Detach the IR cable from the
keypad assembly.
2.2 Figure 8. Remove the two screws securing
the IR board.
2.3 Figure 9. Detach the IR cable from the IR
board.
3. Transducer Removal
3.1 Complete step 1.
3.1 Figure 10. Remove the 4 screws securing
the transducer to the enclosure.
3.2 Figure 11. Detach the transducer cable
from the main PCB.
Note: Use a screw driver or spudger to unlock
the locking tab for the transducer cable.
Figure 7. Keypad, IR Cable Removal
Figure 8. IR PCB, Screws
Figure 9. IR PCB, IR Cable Removal
Figure 10. Transducer, Screws
Figure 11. Transducer, Cable