29
DISASSEMBLY PROCEDURE
Main/ Carrier PCB Removal (continued)
5.10 Figure 27. Remove the 3 screws secur-
ing the main PCB.
5.11 Figure 28. Then lift the assembly port up
a little bit to create some space in between the
port and the main PCB.
5.13 Figure 29. With the port held up, slide the
main PCB outward from the cabinet following
the direction of the arrow.
Note: To avoid damage to the main PCB. The
port must be slightly held up to create a gap
for the PCB to slide through.
Figure 27. Main PCB, Screws
Figure 28. Main PCB, Port
Figure 29. Main PCB, Removal
To Next Page
Loading...
