28
DISASSEMBLY PROCEDURE
Main/ Carrier PCB Removal (continued)
5.5 Figure 22. Detach the FFC from main
PCB.
5.6 Figure 23. Detach the transducer cable
from the main PCB.
Note: Use a screw driver or spudger to unlock
the locking tab for the transducer cable.
5.7 Figure 24. The cabinet and the rear panel
are now separated.
5.8 Figure 25. Remove the acoustic foam from
the cabinet if needed as shown.
5.9 Figure 26. Detach the AC connector.
Figure 22. Main PCB, FFC
Figure 23. Main PCB, Transducer Cable
Figure 24. Cabinet, Internal
Figure 25. Cabinet, Acoustic Foam
Figure 26. Main PCB, AC Connector
To Next Page
Loading...
