31
ASSEMBLY KEY POINTS
When assembling the unit, reverse the disassem-
bly procedures. The following assembly instruc-
tions provide key points that are important to
consider when assembling the unit.
1. Replacing AC connector’s gasket foam.
1.1 Figure 32. When the AC socket part
739368-0010 is removed, the gasket foam will
deform and cause an air leak. A gasket foam
replacement is needed. Gasket Foam Part
730055-0010.
! Important: The AC socket is considering a
safety device and must be properly installed.
2. Replacing Port Foam
2.1 Figure 33. A replacement is needed when
the port is removed as the port foam will
deform due to the pressure applied to it. Port
Foam part 73533-0020.
3. Enclosure Foam Replacement.
3.1 Figure 34. A new enclosure foam is need-
ed to prevent an air leak as the gasket foam
for the enclosure might tear upon disassembly
and cause an air leak. Enclosure Gasket foam
part 735334-0020.
4. Keypad PCB foam
4.1 Figure 35. Align the foam to the outline
on the PCB. Press the foam to approximately
3mm of its body height and then release it.
PCB Foam part 747504-0010.
Figure 32. AC Connector, Gasket Foam
Figure 33. Port, Foam
Figure 34. Cabinet, Enclosure Foam
Figure 35. Keypad, Foam
To Next Page
Loading...
