Bose SoundTouch 10 - Page 33

33
TAP COMMAND PROMPT SETUP
5. Then start a new command prompt again and
enter “telnet 203.0.113.1 17000” to get TAP com-
mand prompt.
SoundTouch
®
10 Wi-Fi Music System
TAP command prompt setup
Tap commands are needed for the following
procedures.
A. Audio Test
B. Wi-Fi Test
C. IR Test
D. Keypad Button Test
E. LED Test
Equipment Required
Hardware
Computer with USB ports.
USB A to MICRO B cable P/N 743203-052210.
Software
Window Command Prompt.
Bose
®
SoundTouch software.
Please follow these instructions to setup your
SoundTouch 10 device.
1. Get a PC and install Bose Soundtouch soft-
ware. To download Soundtouch software, go to
http://worldwide.bose.com/downloads/en/web/
soundtouch_download/page.html
Note: The Soundtouch software will take care of
the PC USB driver so it has to be installed before
connecting the SoundTouch 10 to the PC through
USB cable.
2. Insert the USB and then AC cord.
3. Boot the SoundTouch 10 and wait for 3 (three)
minutes. All four LEDs should be on at the same
time. Then White LED start to blinking between
Wi-, Bluetooth, AUX and Shelby. The boot se-
quence is completed when you see Wi-Fi Amber
LED light up.
4. Run a command prompt, then enter “ipcong”
command to verify a new network interface name
“SoundTouch
TM
System” is discovered (with ip
address 203.0.113.2).
Note: if the SoundTouch is not seen using “ipcon-
g” command, go to device manager and conrm
the network adapter is enabled.
6. Once telnet session succeed , you will have
the TAP command prompt.