Bose SoundTouch 10 - Page 35

35
WI-FI TEST PROCEDURE
2.2 The song “Take 5” should play. Listen for
clean undistorted audio.
2.3 Enter the following TAP command to exit
the Wi-Fi test.
“demo exit”
3. Factory Default Unit
3.1 Enter the TAP command “sys factoryd-
efault”. The unit should turn off and reboot.
Note: Do not disconnect or remove the power
to the unit until the reboot cycle has complet-
ed.
3.2 Provide the customer instructions for
re-connecting their system to their Wi-Fi
network. Download instructional sheet on the
repair information page.
Note: Factory default process has to be carry
out to reset all the settings to prevent the cus-
tomer from receiving the unit with repair test
settings.
Wi-Fi Functional Test Set Up
This test uses TAP commands to connect the
product to a Wi-Fi network and stream audio from
a Bose
®
URL. Refer to pages 33 steps 1-6, for
telnet Setup. The Bose SoundTouch
®
application
can be used in place of this test.
Note: Do not download the audio le from the
test URL.
Note: A zip le with the automated commands
“Soundtouch 10 Wi Test.vbs” below is available
for download on the Bose product’s repair infor-
mation page.
Once downloaded, double-click “ Soundtouch 10
Wi Test.vbs” to run the test.
You need to key in the Wi-Fi SSID name and
password according to your router per request.
1. Connecting to Wi-Fi Router.
1.1 Run a command prompt and enter “telnet
203.0.113.1 17000” to get the TAP command
prompt.
1.2 Enter “async_responses on”
1.3 Enter “ network wi- proles add ROUTER
NAME wpa_or_wpa2 PASSWORD”
2. Testing the Wi-Fi Module.
2.1 Enter the following TAP commands.
“sys conguration DemoAudioURL http://
worldwide.bose.com/downloads/assets/audio/
take5.mp3”
“sys conguration DemoNetworkEnabled true”
“sys volume 30”
“demo enter”