41
SERIAL NUMBER AND COUNTRY/REGION CODE PROGRAMMING
Important! The replacement Wi-Fi PCB needs
to have various settings performed and end user
software loaded. Below are the steps that need
to be performed when a replacement Wi-Fi PCB
is used.
Refer to page 40, step 1-9 for Manufacturing
mode setup and to get the Manufacturing
command prompt.
Note: A Tera-Term macro that includes the TAP
commands below is available for download on
the product’s repair information page. Place the
macro le in the same folder as your Tera Term
program. Open Tera-Term, select Control, Macro,
“Soundtouch 10 WIFI_module_settings.ttl”. Once
the macro runs, follow the prompts.
1. Set Variant
1.1 Enter “/opt/Bose/mfgdatatool –w variant
XX”.
Where XX equals:
rhino = SoundTouch
®
10
spotty = SoundTouch 20
mojo = SoundTouch 30
lisa = SoundTouch adapter
2. Set Country Code
The country code controls the allowable WiFi
frequencies (2.4GHz and 5GHz bands) for the
geographical region that the product will be sold
in.
2.1 Enter “/opt/Bose/mfgdatatool –w country-
code XX”.
Where XX equals:
• CN – Australia, Hong Kong, UAE, India,
China.
• GB – Germany, Austria, Switzerland,
Italy, France, Belgium, Nether-
lands, Denmark, Sweden, Norway,
Finland, UK, Hungary, Poland.
• US – USA, Canada, Latin America.
• TW – Taiwan.
• JP – Japan.
3. Set Region Code
The region code controls the allowable power lev-
els (2.4GHz and 5GHz bands) for the geographi-
cal region that the product will be sold in.
3.1 Enter “/opt/Bose/mfgdatatool –w region-
code XX”.
Where XX equals:
• GB – Australia, Hong Kong, UAE, India,
China, Germany, Austria,
Switzerland, Italy, France,
Belgium, Poland, Netherlands,
Denmark, Sweden, Norway,
Finland, UK, Hungary.
• US – USA, Canada, Taiwan, Latin -
America.
• JP – Japan.
4. Set Serial Number
4.1 Enter “/opt/Bose/mfgdatatool –w sn 1 seri-
al number”.
Where serial number equals the 17 digit serial
number located on the product’s label.
5. Set Variant Mode
To set the unit from manufacturing status to
normal status.
5.1 Enter
“/opt/Bose/mfgdatatool –w variantmode nor-
mal”.
6. Load End User Software Image
6.1 Download the latest software from the site
below and load it onto a USB thumb drive.
http://worldwide.bose.com/downloads/en/web/
soundtouch_updates_usb/page.html
To Next Page
Loading...
