29
WI-FI PCB REPLACEMENT SETTINGS
Important! The replacement Wi-Fi PCB needs
to have various settings performed and end user
software loaded. Below are the steps that need
to be performed when a replacement Wi-Fi PCB
is used.
Refer to TAP command setup on page 38-39
Note: A Tera-Term macro that includes the TAP
commands below is available for download on
the product’s repair information page. Place the
macro file in the same folder as your Tera-Term
program. Open Tera-Term, select Control,
Macro, WIFI_module_settings.ttl. Once the
macro runs, follow the prompts.
1. Set Country Code
The country code determines the allowable
Wi-Fi frequencies for where the product is
sold.
1.1 Type
/opt/Bose/mfgdatatool –w countrycode XX
Where XX equals: (UPPERCASE)
• CN - Australia, Hong Kong, China, UAE, India
• GB - Germany, Austria, Switzerland, Italy,
France, Belgium, Netherlands, Denmark,
Sweden, Norway, Finland, UK, Hungary,
Poland
• US - USA, Canada, Latin America
• TW - Taiwan
• JP - Japan
2. Set Region Code
The region code determines the allowable
power levels for where the product is sold.
2.1 Type
/opt/Bose/mfgdatatool -w regioncode XX
(UPPERCASE)
• GB - Australia, Hong Kong, China, UAE,
India, Germany, Austria, Switzerland, Italy,
France, Belgium, Netherlands, Denmark,
Sweden, Norway, Finland, UK, Hungary,
Poland
• US - USA, Canada, Latin America, Taiwan
• JP - Japan
3. Set Variant
3.1 Type (lowercase)
/opt/Bose/mfgdatatool –w variant spotty
(spotty = SoundTouch 20)
3. Set Serial Number
3.1 Type
/opt/Bose/mfgdatatool –w sn 1 serial number
Where serial number equals the 17 digit serial
number located on the product’s label.
4. Set Variant Mode
4.1 Type (lowercase)
/opt/Bose/mfgdatatool –w variantmode normal
5. Verify settings
5.1 Type
/opt/Bose/mfgdatatool -p
The system settings will be displayed.
6. Load End User Software Image
6.1 Download the latest software from the site
below and load it onto a USB thumb drive.
http://worldwide.bose.com/downloads/en/web/
soundtouch_updates_usb/page.html
6.2 Insert the thumb drive into the units Setup
B USB port.
6.3 Reboot the unit. While the unit is booting,
press and hold the shift key while repeatedly
pressing “U” until you see the Uboot prompt.
U-Boot#
6.4 Type “sweup uboot”.
6.5 When the update is complete, remove and
reapply power. The unit’s display will show the
picture of the owners guide. This indicates it
now has the end user software image.
Note: Units with the manufacturing software
image will have a screw driver and wrench on
the display and the words Test Mode.
To Next Page
Loading...
