30
WI-FI TEST PROCEDURE
1. Wi-Fi Functional Test Set Up
This test uses TAP commands to connect the
product to a Wi-Fi network and stream audio
from a Bose
®
URL. Refer to pages 31 and 32,
TAP Command Setup. The Bose
®
SoundTouch
®
application can be used in place
of this test. Note: Do not download the audio
file from the test URL.
Note: A Tera-Term macro that includes the
TAP commands below is available for
download on the product’s repair information
page. Place the macro file in the same folder
as your Tera-Term program. Open Tera-Term,
select Control, Macro, wifi_test.ttl. Once the
macro runs, follow the prompts.
2. Connecting to a Wi-Fi Router
2.1 Turn on asynchronous response
->async_responses on
2.2 Add router name and password
->network wifi profiles add ROUTERNAME
wpa_or_wpa2 PASSWORD
2.3 Wait for the Wi-Fi indicator on the
product’s display to turn solid white. This may
take up to a minute. If the indicator does not
turn white, enter the TAP command again.
3. Testing the Wi-Fi Module.
3.1 View Current system confi guration
“getpdo CurrentSystemConfi guration” will
print
out the current values
3.2 Enter location of demo URL
“sys confi guration DemoAudioURL http://
worldwide.bose.com/downloads/assets/audio/
take5.mp3"
3.3 Enable Demo
“sys confi guration DemoNetworkEnabled
true”
3.4 Enter Demo mode
“demo enter”
3.5 Exit Demo Mode
“demo exit” or “sys reboot”
4. Factory Default Unit
4.1 Enter the TAP command
sys factorydefault
4.2 Provide the customer instructions for re-
connecting their system to their Wi-Fi
network. Download instructional sheet on the
repair information page.
To Next Page
Loading...
