35
BACK DOOR KEY PRESSES
1. System Information
1.1 Press and hold the Volume (-) minus and
Preset 5 to bring up System Information. Use
the Volume (-) minus and plus to toggle
through the items.
1. MAC address
1.1 Ethernet MAC address
1.2 Wi-Fi MAC address
2. Network Information
2.1 Connection Type
2.2 IP Address
2.3 SSID
2.4 RSSI (Received Signal Strength),
rates Wi-Fi signal received strength
3. System Information
3.1 Component ID
3.2 System Serial number
3.3 Component ID (Wi-Fi)
3.4 Wi-Fi Module Serial Number
3.5 Wi-Fi Module Firmware
4. SoundTouch Information
4.1 Wi-Fi Module Serial Number
4.2 Bose Application Firmware
5. SoundTouch Controller Information
5.1 Connected:yes/no
6. Battery Information
6.1 Serial Number
6.2 Firmware
6.3 Manufacturer
6.4 Build Date
2. Factory Default
2. Press and hold the Volume (-) minus and
Preset 1. The system will return to factory
default settings and reboot. The TAP com-
mand “sys factorydefault will also
3. Software Update
3.1 Press and hold the Volume (-) minus and
Preset 4 to initiate a software update.
3.1.1 The unit will load the software update
over Wi-Fi.
3.1.2 To update the software with a thumb
drive, feset the system with the AUX
button. Then press and hold Volume (-)
minus and Preset 4 within a second of the
reset to initiate a software update. See
page 25 for detailed instructions.
4. Alternate Setup (connect unit to Wi-Fi
network)
4.1 Press and hold the Volume (-) minus and
Preset 2 to initiate alternate setup mode.
4.2 Connect a smartphone, iOS device, or
Wi-Fi enabled PC to the unit’s Bose
®
Soundtouch Wi-Fi network.
4.3 The units Wi-Fi setup page IP address
will be shown on the unit’s display. Enter the
IP address into smart phone browser and
follow the directions on the page.
5. Disable/Enable Networking
5.1 Press and hold the Volume (-) minus and
Preset 3 to enable or disable networking.
6. Product Reset
6.1 Press and hold AUX button for 12-15
seconds.
To Next Page
Loading...
