32 - English
Apendices
Appendix B: Wall mounting the
SoundTouch™ wireless adapter
You can mount the adapter on a wall (hardware not included). See “Mounting
hardware specifications” for the correct hardware.
Mounting hardware specifications
Item Wood Wallboard
Wall thickness
1 in. (25.4 mm) or thicker
⅜ in. (9.5 mm) or thicker
Drill bit ⅛ in. (3.17 mm) ³/16 in. (4.76 mm)
Pan-head wood screws (2)
#8x1¼ in. (32 mm) #8x1¼ in. (32 mm)
Plastic wall anchors (2)
Not used #6-8x1 in. (25.4 mm)
If the mounting hardware instructions differ from these instructions, follow the
mounting hardware instructions.
There are two ways to mount the adapter:
• Vertically; connector panel facing left
• Horizontally; connector panel facing up
1. Drill two holes 6¼ in. (159 mm) center-to-center.
2. Insert plastic wall anchors (if mounting to wallboard).
3. Install pan-head wood screws.
Note:
Leave the screw heads ¼ in. (6.35 mm) above wall surface.
4. Position adapter onto the screws.
6¼ in. (159 mm)
center-to-center
To Next Page
Loading...
