To Next Page

To Previous Page

English – 11

Tab 6, 14

Tab 2, 10 Tab 3, 11 Tab 4, 12 Tab 5, 13

Tab 8, 16Tab 7, 15

USING YOUR WAVE

CONNECT KIT

Docking your iPod

Insert your iPod firmly into the dock and make sure it is securely seated in the dock

adapter. Your iPod turns on in a paused state and begins charging, as needed. Even

if the paused iPod turns off automatically, it continues to charge.

If you prefer, you can replace this dock adapter with the

adapter specifically designed for and provided with your

iPod. Use a fingernail or a slender tool carefully to pry the

adapter free, as shown.

Playing your iPod

Be sure to aim the remote so its signals reach the IR sensor on the front of the dock.

Then use these buttons as follows:

Press AUX to turn on your system and begin iPod playback.

Press Play/Pause to pause or resume iPod play.

Press Tune/MP3 to move from one playlist to another. Then press

Play to hear that list play.

Press Seek/Track once to skip back or ahead one track.

Press and hold Seek/Track to scan through a track.

Press Volume to adjust the sound volume.

Note: Volume changes using the iPod controls will not affect the

Wave

system volume.

Press On/Off once to turn off both products, aiming the remote at the

dock until the iPod turns off.

Press any source button to turn off the iPod and listen to that source.

Seek/Track

Replay_OG Wave.book Page 11 Tuesday, November 15, 2011 4:12 PM

Bose WAVE connect kit User Manual

Questions and Answers: