12 – English
Tab 3, 11
Tab 8, 16 Tab 7, 15 Tab 6, 14 Tab 5, 13 Tab 4, 12
Tab2, 10
USING YOUR WAVE
®
CONNECT KIT
Troubleshooting
Problem What to do
The remote does not
control the iPod
Press AUX to reset the mode of operation for
the iPod.
You may then need to press Play/Pause to
resume play.
The iPod is on when it
should not be
If the system is off or you are playing another
source, press AUX.
Then press On/Off or another source button.
With the remote aimed properly, your iPod should
turn off within 2 seconds.
The volume varies
when the iPod plays
different songs
Use Volume to set the volume to the level you
prefer for a particular song.
The recording quality of songs varies, producing
inconsistent play volumes.
Poor AM reception Make sure the iPod is turned off to help prevent
interference. (Refer to “The iPod is on when it
should not be.”)
Position the dock to the right of the system to
minimize interference with the built-in AM antenna.
The iPod is connected
to the Multi-CD
Changer and it is on
but does not play
Be sure the audio cable from the dock is connected
to INPUT AUX 1 on the changer.
Press AUX and check to see that AUX 1 appears on
the Wave
®
system display.
You may then need to press Play/Pause.
The Wave
®
system
speakers play even
when headphones
are plugged into the
docked iPod
Connect the headphones to the mini jack on the
Wave
®
system.
This silences the system so the sound plays through
the headphones only.
Replay_OG Wave.book Page 12 Tuesday, November 15, 2011 4:12 PM
To Next Page
Loading...
Need help?
General
