12 – English
LISTENING TO RADIO
Re-scanning digital radio stations
You can re-scan for available digital radio stations at any
time DIGITAL RADIO is selected. This capability is useful
if you change the location of the Wave
®
music system III
or decide to connect the external antenna.
1. Press and hold Mute until “AUTOSCAN”
is displayed, followed by
“PRESS PRESET 3 TO CONFIRM.”
2. Press the Presets 3 button. The message,
“PLEASE WAIT SCANNING” appears on the
display until scanning is finished.
When scanning is finished, the first primary station is
played.
Displaying station information
There are three ways to display information about the
currently playing digital station:
• Station name (default setting):
• Current program content:
• Program type:
To change the way station information is
displayed, press Play Mode until the type of
information you want is displayed.
Displaying station signal strength
For the current station, signal strength is displayed as a
numeric percentage of full signal strength and its
classification.
To view the signal strength of the current station,
press and hold Play Mode.
The signal strength ranges are:
Note: If the station is “UNAVAILABLE” or “OFF AIR,” no
signal strength information is available.
Note: Due to the technology used in digital radio broad-
casting, the TALK RADIO mode for FM and AM radio is not
available for digital radio stations.
Percentage Classification
0 - 19 Low
20 - 39 Poor
40 - 79 Moderate
80 - 89 Good
90 - 100 Very Good
Seine_D_OG.book Page 12 Wednesday, November 2, 2011 1:44 PM
To Next Page
Loading...
Need help?
General
