Boss DD-8 - Footswitch Loop Control; Using the TWIST Function; TWIST Function Activation

14
Using the LOOP (Overdubbing) Function
Using a footswitch to control the loop function
If a footswitch (FS-5U, FS-6, FS-7; sold separately) is connected to the
TEMPO/EXP jack, you can stop playback or erase.
* When connecting a footswitch, you must turn o the power
before connecting or disconnecting cables. Failure to observe
this precaution will cause malfunctions.
Footswitch Operation
If one FS-5U unit
is connected
Press the pedal to stop.
Long-press the pedal to delete.
If two FS-5U units
are connected
Press the RING pedal to delete.
Press the TIP pedal to stop.
If an FS-6 or FS-7
are connected
Press switch A to delete.
Press switch B to stop.
Using the TWIST Function
If a footswitch (sold separately: FS-5U, FS-6, FS-7) is connected to
the TEMPO/EXP jack, you can use the TWIST function which creates
an aggressive sense of rotation.
* When connecting a footswitch, you must turn o the power
before connecting or disconnecting cables. Failure to observe
this precaution will cause malfunctions.
* Twist function cannot be used in LOOP mode.
Footswitch Operation
If two FS-5U units
are connected
Press the RING pedal to apply the TWIST
eect.
If an FS-6 or FS-7
are connected
Press switch A to apply the TWIST eect.
* If only one FS-5U unit is connected, the TWIST function
cannot be used.