Boss DD-8 - Setting the Mode for Stereo Delay; Stereo Delay Mode Selection

18
Setting the Mode for Stereo Delay
When using the DD-8 as a stereo delay, you can choose among
three dierent types of stereo delay eect.
* For detailed information on how to make the connections for
stereo delay, refer to “Stereo” (p. 16).
1. Make the connection to the INPUT-A (MONO) jack
and leave nothing connected to the INPUT-B jack.
2. Hold down the pedal switch and insert the plug to
INPUT-B jack.
The setting mode for stereo delay is enabled, and the CHECK
indicator lights in orange.
3. Select the stereo delay eect.
Use the [MODE] knob to select the mode for stereo delay.
MODE knob Eect Explanation
LOOP panning Panning delay.
ANALOG wide stereo
Stereo delay with a
sense of wide space
in the reverberant
sound.
STANDARD
completely
independent
stereo
Completely
independent delays
for A and B.
MODE knob Eect Explanation
TAPE
panning Panning delay.
WARM
REVERSE
+RV
SHIM
MOD
GLT
WARP
* With the factory settings, this is set to “Completely
independent delays for A and B”.
4. Save the settings.
Press the pedal switch to make the CHECK indicator rapidly ash
in orange and save the settings.
After the settings have been saved, the unit returns to normal
operation.
* Never switch o the power while the CHECK indicator is
ashing rapidly.
* This setting is retained even while the power is turned o.