Bostitch N66C User Manual

OPERATION and MAINTENANCE MANUAL
MANUAL DE OPERACIÓN Y DE MANTENIMIENTO
MANUEL D’INSTRUCTIONS ET D’ENTRETIEN
N66C
COIL-FED PNEUMATIC NAILER
CLAVADORA NEUMÁTICA ALIMENTADA POR ROLLO
CLOUEUR PNEUMATIQUE À ENROULEMENT
160180REVF 8/07
BEFORE OPERATING THIS TOOL, ALL OPERATORS SHOULD STUDY THIS MANUAL TO
UNDERSTAND AND FOLLOW THE SAFETY WARNINGS AND INSTRUCTIONS. KEEP THESE
INSTRUCTIONS WITH THE TOOL FOR FUTURE REFERENCE. IF YOU HAVE ANY QUESTIONS,
CONTACT YOUR BOSTITCH REPRESENTATIVE OR DISTRIBUTOR.
ANTES DE OPERAR ESTA HERRAMIENTA, TODOS LOS OPERADORES DEBERÁN ESTUDIAR
ESTE MANUAL PARA PODER COMPRENDER Y SEGUIR LAS ADVERTENCIAS SOBRE
SEGURIDAD Y LAS INSTRUCCIONES. MANTENGA ESTAS INSTRUCCIONES CON LA
HERRAMIENTA PARA FUTURA REFERENCIA, SI TIENE ALGUNA DUDA, COMUNÍQUESE CON
SU REPRESENTANTE DE BOSTITCH O CON SU DISTRIBUIDOR.
LIRE ATTENTIVEMENT LE PRÉSENT MANUEL AVANT D’UTILISER L’APPAREIL. PRÉTER UNE
ATTENTION TOUTE PARTICULIÈRE AUX CONSIGNES DE SÉCURITÉ ET AUX
AVERTISSEMENTS. GARDER CE MANUEL AVEC L’OUTIL POUR FUTUR RÉFÉRENCE. SI
VOUS AVEZ DES QUESTIONS, CONTACTEZ VOTRE REPRÉSENTANT OU VOTRE
CONCESSIONNAIRE BOSTITCH.
STANLEY FASTENING SYSTEMS L.P.

Bostitch N66C Specifications

General

Operating Pressure	70-120 PSI
Fastener Range	1-1/4" to 2-1/2"
Depth Adjustment	Yes
Fastener Type	Wire Weld Coil Nails
Magazine Capacity	300 nails

Summary

Safety Instructions

Eye Protection

Operator and others must wear ANSI Z87.1 eye protection against flying particles.

N66C Tool Specifications

Fastener Specifications

Details on nail size, length, and collation for the tool.

Tool Air Fitting

Specifies the required air fitting type and minimum inside diameter.

Operation

Contact Trip

Explains the contact trip operation mode where the tool fires when the contact trip touches the work.

Sequential Trip

Explains the sequential trip operation mode requiring trigger activation after contact.

Air Supply and Connections

Fittings

Details on installing a free-flowing male plug for quick disconnection.

Hoses

Specifies minimum working pressure and quick disconnecting fittings for air hoses.

Supply Source

Regulator

Operating Pressure

Warns against exceeding recommended pressure to prevent tool wear.

Filter

Loading the N66C

To Prevent Accidental Injuries

Tool Operation

Contact Trip Operation

Sequential Trip Operation

Maintaining the Pneumatic Tool

Trouble Shooting

Coil Nailers