Accessing the Clinician Menu
Vercise™ DBS Remote Control 4 Directions for Use
92378769-02 27 of 1157
CP Mode: Stimulator
The Remote Control can be used to establish communication between the implanted Stimulator (IPG)and
Clinician Programmer (CP) for device programming. The Stimulator can be placed into CP Mode (Pairing
Mode) by following the steps below. Alternatively, you may utilize the shortcut method described in the
“Basic Operation” section of this manual.
From the
Clinician Menu:
1. Select
CP Mode: Stimulator.
2. Connect the CP to the Stimulator and proceed with device programming.
3. Press to exit CP Mode.
Note: CP Mode (Pairing Mode) must be enabled for the CP to connect to and program the Stimulator
using Bluetooth communication.
To Next Page
Loading...
Need help?
General
