Vercise™ DBS Remote Control 4 Directions for Use
Vercise™ DBS Remote Control 4 Directions for Use
92378769-02 30 of 1157
MRI Mode
A patient implanted with an MR Conditional DBS System can undergo an MR Conditional Scan when all
instructions listed in the ImageReady
TM
MRI Guidelines for Boston Scientic DBS Systems are followed,
including enabling MRI Mode on the Stimulator. Contact Boston Scientic Technical Support or go to
www.bostonscientic.com/manuals for the latest version of this manual.
Enabling MRI Mode
When the Remote Control is linked to an MR Conditional Stimulator, the Enter MRI Mode icon will
appear on the System Settings screen. The Remote Control must be used to enable MRI Mode on the
Stimulator before performing an MRI scan on a patient. Once the MRI scan is complete, disable MRI
Mode. Do not leave the Stimulator in MRI Mode for extended periods of time beyond what is necessary to
perform the MRI scan. The stimulation is automatically turned OFF when MRI Mode is enabled.
Warning: Do not perform an MRI scan if MRI Mode is not enabled. Scanning under different
conditions may result in patient injury or device malfunction.
To enable MRI Mode:
1. Unlock the Remote Control by pressing the Lock/Unlock
button on the right side of the Remote
Control.
2. After unlocking the Remote Control, the Home screen appears.
Note: The Remote Control may display either a text screen in one of the languages provided or an
iconic screen.
3. Press the Right Arrow
button to navigate to the Main Menu.
To Next Page
Loading...
Need help?
General
