6.3 Data exchange
1. Press and hold [BLACK-OUT] for three seconds.
2. Press [PROGRAM] and [BLACK-OUT] simultaneously. If the device has stored scenes, the
display shows ‘OUT’, indicating that data can be sent. Otherwise the display shows
‘EPTY’ – all programs are empty.
3. Make sure that the receiving device is in Receive mode to fully receive the file.
4. Press [FADE+SPEED/DEL] to send the data set. During sending, no other functions are
accessible.
5. When sending is complete, the display shows ‘END’. Press any button to exit this mode.
Sending data
Operating
SD-10
31
DMX recorder
To Next Page
Loading...