EasyManua.ls Logo

Boulder 2008 - Troubleshooting

Boulder 2008
36 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
APPENDIX
7-3
TROUBLESHOOTING
______________________________________________________________________________________________________________
SYMPTOM CAUSE REMEDY
______________________________________________________________________________________________________________
No power indication on 2000 Power switch is not on Turn on power switch
_________________________________________________________________________
Preamplifier is not plugged in Connect to an AC outlet
_________________________________________________________________________
Home circuit breaker is tripped Reset circuit breaker
______________________________________________________________________________________________________________
Red power indication on 2000 Low line voltage Have line voltage checked
_________________________________________________________________________
Power supply’s breakers tripped Reset breakers on rear panel
_________________________________________________________________________
Defective power supply cables Have cables tested
_________________________________________________________________________
Defective power supply or preamp Return to dealer for service
______________________________________________________________________________________________________________
Amber POWER indication on 2008, Preamp is muted, MUTE is red Push MUTE so indicator is off
_________________________________________________________________________
but no sound is heard No signal from turntable Check turntable connections
_________________________________________________________________________
No signal out to preamplifier Check connections to preamp
_________________________________________________________________________
No power supply to channel(s) Turn off power supply, check cables
_________________________________________________________________________
Preamp is faulty Return to dealer for servicing
______________________________________________________________________________________________________________
Hum is heard No ground connection Check or install ground wire
_________________________________________________________________________
Duplicate ground connection Use only one ground wire to
turntable, or use the ground in a
balanced cable
_________________________________________________________________________
Preamp or turntable is too close to Move preamp and/or turntable
2000 or other power supply away from power supply
_________________________________________________________________________

Related product manuals