Bounty Hunter Treasure detector - Page 4

I. ASSEMBLY: (continued)
2) Attach the Upper Stem to the back of the
detector body with the two knobs supplied.
3) Depress the button on the lower stem and
push the lower stem into the upper stem.
4) Wind the searchcoil cable around the
two-piece stem.
5) Leave some slack in
the cable as you
reach the end of
the lower stem.
6) Attach the coil to
the lower stem using
the attached coil knob.
7) Install two (2) 9-volt
ALKALINE batteries (not
supplied).
There are two battery doors on the
back of the detector body.
IMPORTANT: use 9-volt ALKALINE
batteries ONLY.
Lower
Stem
Searchcoil
Coil Knob
Knurled 
Coil Knob
I. ASSEMBLY: (continued)
2) Attach the Upper Stem to the back of the
detector body with the two knobs supplied.
3) Depress the button on the lower stem and
push the lower stem into the upper stem.
4) Wind the searchcoil cable around the
two-piece stem.
5) Leave some slack in
the cable as you
reach the end of
the lower stem.
6) Attach the coil to
the lower stem using
the attached coil knob.
7) Install two (2) 9-volt
ALKALINE batteries (not
supplied).
There are two battery doors on the
back of the detector body.
IMPORTANT: use 9-volt ALKALINE
batteries ONLY.
Lower
Stem
Searchcoil
Coil Knob
Knurled 
Coil Knob