7 Preparation
MN031-447-S0-20101217-EN NightKNIFE / Ligator 39
Shank tube
NOTE
Risk of material damage to shank tube from metal
brushes!
Use only the plastic brushes supplied with the
instrument to clean the shank tube.
If necessary, use a steam sprayer for cleaning.
2
3
1
1. Use the small cleaning brush to clean the inside of the
proximal end 3 of the shank tube.
2. Use the large cleaning brush to clean the inside of the
distal end 1 of the shank tube.
3. Rinse the distal end of the shank tube B with fully
demineralized water or distilled water to clean the inside
of the housing. At the same time, actuate the trigger 2 to
clean the actuation mechanism inside the housing.
MN031-447-S1 EN
To Next Page
Loading...
