BÖWE P 300 - Machine Fixing Methods

11
5. Machine fixing
5.1 Machine trough
The machine trough is a permanently integrated part of the machine.
Capacity: 245 l / 64.5 US gal Slimline, 290 l / 76.6 US gal Crossline
Material: St1203 /1.0330.03 /3 mm (0.1 inch)
lacquered
5.2 Anchoring methods
The following anchoring methods can be
alternatively used:
- For installation over ceilings
through bolt (threaded rod)
with washer and nuts M12
- For installation foundation
Stone bolt (length 100 mm/3.9 inch) for cementing in
recessed or morticed holes
(Bolts must not be longer, than the thickness of
the foundation.)
or M12
Heavy-load plugs with threaded rod
in deep bore-holes
or
Safety expanding anchors for inserting
in bore holes
or
adhesive plugs /shear connector. 703871-25-0
Thread for all fixing methods: M 12
Quality: Property class 8.8 - DIN 267
We are not liable for any damage caused by disregarding of our recommendations
and of our information.
Attention
Pay attention to the floor load of the machine floor surface.
The bore holes must be deep enough, to ensure that the plug is
under tension in the conrete.