Bowflex BXT116 - Page 92

92
1. With power supplied to the machine and it turned on, adjust the Walking
Deck Incline to a setting of ‘6’. To adjust, push the ‘6’ Pre-Set Incline but-
ton,andthentheConrmInclinebutton.AllowtheWalkingDecktoadjust
to the new incline height.
2. Unplug the power cord from the machine and wait 5 minutes. Place the
power cord in a secure location.
!
To reduce the risk of electrical shock or unsu-
pervised usage of the equipment, always unplug
the power cord from the wall outlet and wait 5
minutes before cleaning, maintaining or repair-
ing this machine. Place the power cord in a
secure location.
3. Using a #2 Phillips screwdriver, remove the screw (indicated by ovals)
from each of the Base Shrouds.
4. Remove the Base Shrouds from the machine.
5. Using a #2 Phillips screwdriver, remove the 10 indicated screws that
secure the Motor Cover.
Note: There are 2 screws that secure the Motor Cover from the underside
of the machine (see image to the right).
(on each side of the Motor
Cover)
Right Base Shroud
Left Base
Shroud
Motor Cover