45
Note: Your machine may not match the images provided exactly.
1. Unplug the AC Adapter from the wall outlet and machine.
3. Using a 5mm hex wrench, remove the indicated hardware from the Up-
per Handlebars and remove them.
Note: Be aware that the Upper Handlebars must be supported when
removing the hardware.
2. Using a #2 Phillips screwdriver, remove the 4 screws (2 indicated on
one side) from the Upper Shroud and remove it.
4. Remove the Right and Left Stabilizer Shrouds from the machine (if
equipped).
Right Stabilizer
Shroud
Left Stabilizer
Shroud
Upper Shroud
Left Upper
Handlebar
Right Upper
Handlebar
To Next Page
Loading...
