39
If the Rollers seem to be “off” and not fully tracked on the Rail Assembly,
this procedure may assist.
1. Unplug the AC Power Adapter from the machine and wait 5 minutes.
2. Using a #2 Phillips screwdriver, remove the 1 indicated screw from the
Rear Shroud.
3. Carefully remove the Rear Shroud from the machine. Place a standard
screwdriver behind and near the middle of the Rear Shroud and gently pry
until it just releases. Then move the screwdriver to the bottom and gently
pry until the Rear Shroud comes off.
4. Remove the Caps from the machine.
!
To reduce the risk of electrical shock or unsupervised usage of the equipment, always unplug the power cord from the
wall outlet and the machine and wait 5 minutes before cleaning, maintaining or repairing the machine. Place the power
cord in a secure location.
Rail Assembly
Roller riding
slightly outward
or “off” of the Rail
Assembly
Rail Assembly
Rear Shroud
Cap
Cap
To Next Page
Loading...
