04.001.21.25.0 V4 02.04.2014 13
English
Digital ECOMETER · Operating and Installation Instructions
Taking into operation
On delivery, the digital ECOMETER is in test mode. Bringing a metallic object close to the sensed
area on the display causes „CONT“ to be displayed. „REED“ is displayed when the reed contact is
activated by the magnet.
First of all, the ECOMETER must be set to the required tyre rolling circumference.
--> Setting the tyre rolling circumference, page 14
- It does not change over to normal counting mode until the tyre rolling circumference has been
entered.
- The setting cannot be changed subsequently.
- Even the preset tyre rolling circumference of 3248 mm (for tyre size 385/65 R22.5) must be
confi rmed prior to start-up (--> page 14).
To Next Page
Loading...
Need help?
General