23
Moto3 User Manual
Washing the oil tank
1. Bleed engine oil completely.
2. Disassemble all of the component parts.
3. Clean all of the component parts.
4. Fill with specified oil.
Caution Drain Plug
This job should be done by your local service center.
When the dipstick shows that the oil level is low do not start the engine. Add more oil until it comes to the upper mark on
the dipstick.
Checking the spark plug
1. Open the spark plug cap and use appropriate wrench to screw plugs out.
2. Clean the surface of the spark plug. If there is corrosion or excessive grit on the spark plug then replace them
. 0.6 - 0.7mm
3. Adjust the spark plug gap to 0.6-0.7mm.
4. Please use specified spark plug.
Caution
1. Do not tighten spark plug to much or thread the rings to avoid damaging the cylinder cap.
While the spark plug is out please ensure that no dust or contaminants get into the spark plug hole.
2. The installed spark plugs have been carefully chosen for this bike and will be suitable for most
working ranges. If you replace the spark plug for another type, please consult with our sales
agency first as improper selection will seriously damage the engine.
Upper and lower markers Oil gauge
To Next Page
Loading...