35
Moto3 User Manual
VII : Washing
Washing the motorcycle regularly helps prevent discoloration of the vehicle surfaces and check for damage and oil leak.
Caution
High water pressure may cause damage to the vehicle parts. Avoid flushing the following parts with high-pressure water
when washing the vehicle:
• Wheel hub
• Exhaust pipe
• Lower part of fuel tank and seat
• Carburetor
• Steering lock and ignition switch
• Speedometer
1. Flush the vehicle with clean water after washing it to remove remaining dirt and prevent rusting. The plastic parts
should be cleaned with cloth or sponge soaked with neutral cleaning detergent and then flushed with clean water.
2. Lubricate the drive chain and run the engine at idle speed after the vehicle is cleaned and allowed to dry.
3. Be sure to check the brake system several times before riding the vehicle and troubleshoot it if necessary.
To Next Page
Loading...