J
J
DIGGING CHAIN OPTIONS
2.00" PITCH DIGGING TOOTH STATION SEQUENCE
GENERAL INFORMATION
Every second link on a digging chain is a special link called a digging
station. These digging station links are designed so that digging teeth can
be bolted onto them in a variety of configurations. It is the number and the
make up of these different digging stations that make each chain unique.
The following tables show the number of digging stations there are in
each available 2.00" pitch digging chain. The digging tooth make up of
each digging station is given in code. The key to the code is located at the
below. Thus these charts will tell you what kind of digging tooth arrange-
ment is at each digging station on each digging chain assembly. The actual
parts break down on each digging tooth arrangement is shown on the "Dig-
ging Tooth Station Break Down" diagrams located in this section following
the charts.
DIGGING TOOTH STATION KEY
CR - CENTER CUTTER, RIGHT 6R - 6" RIGHT STATION 8R - 8" RIGHT STATION
CL - CENTER CUTTER, LEFT 6L - 6" LEFT STATION 8L - 8" LEFT STATION
10 - 10" STATION 12 - 12" STATION B - BLANK STATION
TOOTH EVERY STATION
30" BOOM
DIGGING TOOTH STATIONS
5807
7-24-4
TRENCH
WIDTH
TRENCH
WIDTH
TRENCH
WIDTH
36" BOOM
DIGGING TOOTH STATIONS
42" BOOM
DIGGING TOOTH STATIONS
To Next Page
Loading...