Classic Circular 36"/54" Washfountain with Foot Control
WF2605, WF2608 Terrazzo — WF2705, WF2708 Stainless Steel Installation Instructions
Bradley Corporation • 215-603 Rev. M; EN 06-915B
2 4/6/2007
Pre-Installation Information
Operation
Stepping on the foot rail allows the user to activate a valve starting the flow of water.
Supplies required for installation:
• (8) 1/2" lag bolts, screws or other fasteners to anchor washfountain pedestal to floor
• 1" hot and cold water supply lines and fittings (refer to rough-ins on pages 5-6)
• Reducing fittings and 1/2" nom. copper tubing supply lines for types with supplies from above
• 2" drain lines and fittings (refer to rough-ins on pages 5-6)
• Standard 2" P-trap (refer to rough-ins on page 7, special vented trap supplied for B and H type)
• Pipe sealant and plumber’s putty
• 1-1/2" vent pipe on types vented through washfountain column (refer to page 4 for lengths required)
NOTE: Supply lines for one or two washfountains should be 1"; for three washfountains 1-1/4"; for
more than three washfountains pipe size should increase proportionally. Vent pipe to be 1-1/2"
on models vented through Washfountain.
Bradley Classic Washfountain Warranty Information
Product warranties may be found under “Product Information” on our website at www.bradleycorp.com
To Next Page
Loading...