Braeburn 1200NC - User Manual

This thermostat requires 24 Volt AC Power or two (2) properly installed
“AA” Alkaline batteries for proper operation. When connecting 24 Volt
AC Power the batteries may be installed as a backup.
For use only as described in this manual. Any other use
will void warranty.
1000NC
Single Stage Heat / Cool
Conventional and Heat Pump
1 Specifications
2 About Your Thermostat
3 Installation
4 System Testing
5 Setting User Options
6
Operating Your Thermostat
7 Additional Operation Features
8 Thermostat Maintenance
®
Warning
Turn off power to the heating or cooling
equipment before installation.
Attention
For installation by experienced service
technicians only. Follow applicable codes.
1200NC
Up to 2 Heat / 1 Cool
Conventional and Heat Pump
Read all instructions before proceeding.
This thermostat is compatible with:
 t 4JOHMFTUBHFIFBUDPPMDPOWFOUJPOBMBOEIFBUQVNQTZTUFNT
 t $POWFOUJPOBMTZTUFNTVQUPIFBUDPPM/$POMZ
 t 4JOHMFDPNQSFTTPSIFBUQVNQTZTUFNTXJUIBOBVYJMJBSZIFBUTUBHF/$POMZ
 t oNJMMJWPMUIFBUPOMZTZTUFNT
Electrical and control specifications:
 t &MFDUSJDBM3BUJOH7PMU"$
 t BNQNBYJNVNMPBEQFSUFSNJOBM
 t "$1PXFSo7PMUT"$
 t %$1PXFS7PMU%$i""w"MLBMJOF#BUUFSJFT*ODMVEFE
 t $POUSPM3BOHF¡o¡'¡o¡$
 t 5FNQFSBUVSF"DDVSBDZ¡'¡$
Terminations
 t /$o3D3I0#:8($
 t /$o30#:&8(8$
1
Specifications
1000NCW-100-12
Non-Programmable
Thermostats
Model number is located on back of thermostat
Detailed
User Guide

Summary

Specifications

Electrical and Control Specifications

Terminations

Installation

Thermostat Location Recommendations

Install 4-5 ft above floor in area with good air circulation. Avoid drafts, direct sun, etc.

Install the Sub-Base

Mount the sub-base using pilot holes and anchors.

Provide Power

Connect 24VAC power to C terminal or insert AA batteries.

Connect Your Wires

Wiring Terminations Overview

Details terminal functions for Rc, Rh, O, B, Y, G, W, C.

Additional Terminations (1200 NC)

Lists W1/E and W2 terminal functions for 1200NC models.

Wiring Configurations: Conventional Systems

Wiring: 2 H;1 C Conventional (1200 NC)

Wiring Configurations: Heat Pump Systems

Set Installer Switches

Installer Switch Settings

Attach Thermostat to Sub-Base

System Testing

System Testing Procedure

Operating Your Thermostat

Setting System Control Mode

Explains how to select COOL, OFF, or HEAT modes using the SYSTEM switch.

1200 NC: Emergency Heat Mode

Describes the EMER mode for heat pump emergency heat.

Setting Fan Control Mode

Explains how to select AUTO or ON fan modes.

Temperature Adjustment

Press A or V buttons to adjust the current set point temperature.

Status Indicators

Explains indicators for HEAT, COOL, and AUX status in the display.

Resetting the Thermostat

Thermostat Maintenance

Changing the Batteries

Thermostat Cleaning

Braeburn 1200NC Specifications

General

Brand	Braeburn
Model	1200NC
Category	Thermostat
Language	English