Braeburn 1200NC - Set Installer Switches; Installer Switch Settings; Attach Thermostat to Sub-Base

Factory Setting
Switch Default Options Comments
5
Heat Pump Systems (cont.)
NOTES - Heat Pump Systems
[1]*GCBUUFSJFTBSFJOTUBMMFEUIF7PMU"$DPNNPODPOOFDUJPOJTPQUJPOBM
[2]4FMFDUOGPSDPPMBDUJWFPS BGPSIFBUBDUJWF
[3]*OTUBMMBmFMETVQQMJFEKVNQFSCFUXFFOUIFW2 and EUFSNJOBMTJG
 UIFSFJTOPTFQBSBUFFNFSHFODZIFBUSFMBZJOTUBMMFE
Provide disconnect and overload protection as required.
/03.)1/03.
 '$ '
 )&)( )(
Set Installer Switches
4
/03. 4FMFDUGPSDPOWFOUJPOBMTZTUFNT
 )1 4FMFDUGPSIFBUQVNQTZTUFNT
 ' 4FMFDUGPSGBISFOIFJUUFNQFSBUVSFTDBMF
 $ 4FMFDUGPSDFMTJVTUFNQFSBUVSFTDBMF
 )( 4FMFDUGPSHBTIFBU
 )& 4FMFDUGPSFMFDUSJDIFBU
Attach Thermostat to Sub-Base
5
-JOFVQUIFUIFSNPTUBUCPEZXJUIUIFTVCCBTF
$BSFGVMMZQVTIUIFUIFSNPTUBUCPEZBHBJOTUUIFTVCCBTFVOUJMJUTOBQT
 JOUPQMBDF
NOTE: The reset button should be pressed after making any changes to the
installer switches.
NOTE: The thermostat
hinges from the top
and latches at
the bottom.